Balluff BVS ID-M1280 F1 Series, Configuration Manual

Page: 266 / 316

BVS ID-M1280xF1-xx-xxx
108 english
4.4.6 Events
Event Code Event Type Event – Description – Remedy Device Status
0x1850 (6224) Notification
Process Data profile selection non
applicable – Default value is used.
0 – Device is operating properly.
0x1851 (6225) Notification
Process Data Update Timeout – for
information purposes only
0 – Device is operating properly.
0x1852 (6226) Warning
Several Process Data Update Timeout
– for information purposes only.
0 – Device is operating properly.
0x4000 (16384) Error
Temperature Fault – Overload – The
BVS ID is operated outside of the
device-specific temperature limits.
Risk of device damage
4 – Failure
0x4210 (16912) Warning
Device Temperature Overrun – Clear
Heat Of Source – Risk of device
damage. The BVS ID is too hot.
→ Remove heat source, provide the
BVS ID with heat insulation if
necessary.
2 – Out-of-Specification
0x4220 (16928) Warning
Device Temperature Underrun –
Insulate Device – Risk of BVS ID
damage. The BVS ID is too cold.
→ Insulate the device.
2 – Out-of-Specification
0x5110 (20752) Warning
Primary supply voltage exceeded
→ Check for deviations in the supply.
2 – Out-of-Specification
0x5111 (20753) Warning
Primary supply voltage below
minimum value
→ Check for deviations in the supply.
2 – Out-of-Specification
0x8CD0 (36048) Warning
Inclination alarm
→
Check installation
1 – Maintenance-Required
0x8CD1 (36049) Warning
Vibration alarm
→ Check machine.
0 – Device is operating properly.
0x8CFF (36095) Warning Low signal quality level 0 – Device is operating properly.
0x8D00 (36096) Warning
The measured value is below the
measurement range. Accuracy cannot
be warranted.
2 – Out-of-Specification
0x8D01 (36097) Warning
The measured value is above the
measurement range. Accuracy cannot
be warranted.
2 – Out-of-Specification
0x8D02 (36098) Warning
The measured value is below the
detection zone, a measured value can
not be determined.
→ check application.
2 – Out-of-Specification
0x8D03 (36099) Warning
The measured value is above the
detection zone, a measured value
cannot be determined.
→
check application.
2 – Out-of-Specification
0x8D04 (36100) Warning
A measured value can not be
determined.
→ check application.
2 – Out-of-Specification
0x8D05 (36101) Warning
Measurement errors/redundancy
check failed.
→ check application.
2 – Out-of-Specification
0x8D07 (36103) Warning
The calculation of the basic statistics
was stopped automatically to avoid a
buffer overflow.
0 – Device is operating properly.
0x8D0B (36107) Warning
Overload or short circuit at pin 2
→ check wiring.
2 – Out-of-Specification
0x8D0D (36109) Warning
Wrong load/cable break, analog
power output pin 2
→
check cabling or connected
devices.
2 – Out-of-Specification