Balluff BVS HS-Q Series, Operation Manual

Page: 131 / 296

131
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
I 2 of 5 Set Length 2
This feature specifies one of the barcode lengths for I 2 of 5 Length Control on page 129 . Length
2 is the maximum label length if in Variable Length: For variable length decoding, a minimum and
maximum length may be set. on page 231 Mode, or the second fixed length if in Fixed Length:
For fixed length decoding, two different lengths may be set. on page 231 Mode. The length
includes the barcode’s check and data characters.
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
Table . I 2 of 5 Length 2 Setting Examples provides examples for setting Length 2. See page 232
for detailed instructions on setting this feature.
. I 2 of 5 Length 2
Setting
Examples
STEP ACTION EXAMPLES
1 Desired Setting
Ignore This
Length
4 Characters 14 Characters 50 Characters
2
Pad with leading
zeroes to yield
two digits
00 04 14 50
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT I 2 OF 5 LENGTH 2 SETTING
5
Scan Two
Characters From
Appendix 18, Use
the barcodes in
this appendix to
enter numbers as
you would select
digits/characters
from a keypad.
‘0’ and ‘0’ ‘0’ and ‘4’ ‘1’ and ‘4’ ‘5’ AND ‘0’
6 Scan ENTER/EXIT PROGRAMMING MODE
Select I 2 of 5 Length 2 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CI2L2
~
DEFAULT
50 = Length 2 is 50 Characters