www.balluff.com
5
4.
Installation Guide
4.1.
Mechanical Drawing
Figure 1 - Mechanical drawing of -S92 version with a male M12 connector.
4.2.
Mounting
▪
Use 4 screws (M5x25mm) to mount the device.
▪
Tightening torque max. 2.5 Nm. A higher torque can cause damage to the housing or the internal
electronics.
▪
Fix the sensor to a perfectly flat surface.
▪
A 1-axis inclinometer must be mounted vertically. The factory default zero position is with the male
connector pointing down. Sensor can be zero adjusted at any position within the full range.
▪
A 2-axis inclinometer must be mounted horizontally. The factory default zero position is shown in
Figure 3. After installation, sensor can be zero adjusted to eliminate the mechanical offsets within a
±5° offset range.
Figure 2 - Vertical mounting 1-axis inclination
Figure 3 - Horizontal mounting 2-axes inclination
