Balluff / IO-Link BNI IOL-802-000-Z03x
www.balluff.com
24
4
IO-Link Interface
Blinking
frequency /
Runlight
speed
52
hex
The frequency of the blinking in segment mode and the speed of the running segment in
runlight mode can be set in this register. Values between 1 and 5 are accepted. One means the
slowest and five means the fastest blinking or running speed.
Note
The blinking frequency is only valid for 50% duty cycle blinking. The frequency of the
flashing cannot be changed.
Blinking
mode 53
hex
Byte
1
Bit
7
6
5
4
3
2
1
0
D
es
cri
pt
ion
-
-
-
S
eg
men
t 5
flas
hing
S
eg
men
t 4
flas
hing
S
eg
men
t 3
flas
hing
S
eg
men
t 2
flas
hing
S
eg
men
t 1
flas
hing
The segment X flashing bit sets the mode of the blinking.
0 - blinking with 50% duty cycle
1 - flashing
Note
Through this register only the mode of the blinking can be set (either 50% duty cycle or
flash). The blinking of the desired segment must be activated in process data to
enable blinking.
Flexible
mode, LEDxx
settings
A1
hex
…
B4
hex
This register contains the settings for the flexible LEDs. Values from 0x00 to 0xFF are accepted
for each setting. This register can be accessed through the subindices 0, 1, 2, 3, 4 or 5.
Reading/writing the subindex 0 the whole 5 byte data can be accessed. Subindex 1, 2 and 3
contains the red, green and blue color component, subindex 4 is the ON brightness and
subindex 5 is the OFF brightness.
Note
These registers are available from software version 3.0.
The Brightness ISDU register (51
hex
) determines the maximum brightness of each
channel. It is recommended to set the Brightness ISDU register's value to 7F7F7F
hex
in case of using flexible mode.
Byte
0
1
2
3
4
Sub
Index
1
2
3
4
5
D
es
cri
pt
ion
LED color, red
channel
LED color,
green channel
LED color, blue
channel
On brightness
Off brightness
