Balluff BNI EIP-508-105-Z067, Configuration Manual

Page: 57 / 88

www.balluff.com 13 english
3
Configuration via Explicit Messages (continued)
3.4 Fault State
For each output at the port pins, a safe state can be
pre-defined, which should be adopted in the case of a loss
of bus communication.
The
Fault State settings can be implemented via the
following Class Instance Attribute of the Explicit Messages .
Activate / deactivate Fault State
Class Instance Attribute Value
9 (0x09) 1 – m
1)
6 0: Fault State
disabled
1: Fault State
enabled
1) m: Number of outputs
Tab. 3-3: Values for Fault State – Activation/Deactivation
Fault State Action
Class Instance Attribute Value
9 (0x09) 1 – m
1)
5 0: Output on
1: Hold last state
1)
m: Number of outputs
Tab. 3-4: Values for
Fault State – Fault State Action
The Fault State settings are only stored temporarily
in the module. They are deleted again after a
power reset.
In order to ensure a permanent
Fault State
configuration, the configuration must be
programmed via the PLC so that it can be
transferred to the module again when the system
is restarted.
Discrete Output Current Value
Class Instance Attribute Value
9 (0x09) 1 – m
1)
100 1: 1 A
2: 2 A
4: 4 A
2)
1)
m: Number of outputs
2)
Only for Pin 2
Tab. 3-5: Values for Discrete Output Current Value
BNI EIP-508-105-Z067
Network interface