Balluff BNI EIP-502-105-R015, User Manual

Page: 83 / 274

Balluff Network Interface EtherNet/IP™
www.balluff.com
26
6 Configuration via Explicit Messages
Source:
Allen-Bradley Ethernet/IP QuickConnect Application Technique, Page 32
Fault State
A safe state that the port is to take on in the case of a loss of bus communication can be
predefined for each output on the port pins.
The fault state settings can be configured using the following class instance attributes of the
explicit messages.
Enable/Disable
Fault State Class Instance Attribute Value
9 (0x09) 1 – m 6 0: Fault state disabled
1: Fault state enabled
Fault State
Action Class Instance Attribute Value
9 (0x09) 1 – m 5 0: Output on
1: Hold last state
m: Number of outputs
Note
The fault state settings are stored only temporarily in the module. They are deleted
after a power reset.
To ensure a long-term fault state configuration, the configuration has to be
programmed via the PLC so that the settings are transferred to the module again
when the system is restarted.