Balluff BIP LD2-T017-01-EP-S4 Series, User Manual

Page: 50 / 212

Single-point mode
Fig. 6-2:
SSC
SP1
OFF ON
Position value
Hysteresis
Example for presence detection in single-point mode
Index Subindex Access Data
1. Select switching channel. 0x003A 0x00 R/W 0x01: SSC1
0x02: SSC2
0x03: SSC3
0x04: SSC4
2. Move the target to the desired switching point SP1 (SP1 must
lie within the operating range).
3.
Send system command. 0x0002 0x00 W 0x41
4. Set hysteresis (in example for SSC1). 0x003D 0x03 R/W 50…16900 μm
5.
Check teach-in status (as needed). 0x3B 0x00 R 0x11
Two-point mode
The sequence of commands is critical,
otherwise you will only accomplish single-point
calibration!
Fig. 6-3:
SSC
SP2 SP1
OFF ON
Position value
Hysteresis
Example for presence detection in two-point mode
Index Subindex Access Data
1. Select switching channel. 0x003A 0x00 R/W 0x01: SSC1
0x02: SSC2
0x03: SSC3
0x04: SSC4
2. Move the target to the desired switching point SP2 (SP2 must
lie within the operating range).
3. Send system command. 0x0002 0x00 W 0x42
4. Move the target to the desired switching point (SP1 must lie
within the operating range and be greater than SP2).
5. Send system command. 0x0002 0x00 W 0x41
6
IO-Link interface (continued)
18 english
BIP LD2-T017-01-EP _ _ / EP _ _ -S4
Inductive Positioning System