Balluff BAM PC-TL-020-K Series, User Manual

Page: 31 / 106

www.balluff.com 11 english
5.1 Starting up the system
DANGER
Uncontrolled system movement
When starting up, if the position measuring system is
part of a closed loop system whose parameters have not
yet been set, the system may perform uncontrolled
movements. This could result in personal injury and
equipment damage.
►
Persons must keep away from the system’s
hazardous zones.
►
Startup must be performed only by trained technical
personnel.
►
Observe the safety instructions of the equipment or
system manufacturer.
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Turn on the system.
3.
Check measured values and adjustable parameters
(especially after replacing the BTL).
5.2 PROFIBUS startup and configuration
The function and configuration of the PROFIBUS encoder
and implementation in the controller are described in the
configuration guide. You can find the declaration of
conformity for your specific device in the download area at
www.balluff.com .
5.3 Operating notes
– For maintenance purposes the Ex-e
attachment BAM PC-TL-020 must remain unpowered
in the field if the associated plastic protection cap (see
scope of delivery) is attached.
– Regularly check function of the BTL and all associated
components.
– Take the BTL out of operation whenever there is a
malfunction.
– Secure the system against unauthorized use.
5
Startup
BAM PC-TL-020-K_ _/KA_ _-4
Connection cover for magnetostrictive linear position sensor