11
BAE PD-VS-014-05
2.2.6
Repairs
Repair on the Balluff SmartVision Controller may only be carried out by authorised specialist personnel.
ATTENTION
Unauthorised opening and unprofessional repairs will cause fatal shock hazard. Always dis-
connect device from power circuit (pull power plug out) before touching components.
•
Always pull the mains plug before opening the Balluff SmartVision Controller.
•
Only install system expansions which are intended for the Balluff SmartVision Controller. Installation of additional
expansions may damage the system or safety instructions and regulations for radio interference suppression may be
violated. Information as to which system expansions are suitable for installation can be obtained from the technical
customer service or from your outlet.
The warranty is void if you cause defects to the Balluff SmartVision Controller due to installing or replacing system ex-
pansions.
WARNING
Please observe ETUC information.
NOTE
In the interests of product improvement, Balluff GmbH reserves the right to change the tech-
nical data of the product and the content of this manual at any time without notice.
Limitation of liability
All technical data and certifications are only valid for expansions.
No liability is accepted for functional losses when using third party equipment and components.
Tools
You can carry out all assembly work on the equipment with a Phillips screwdriver type PH1 and PH2.
Summary of Contents for BAE0103
Page 1: ...BAE PD VS 014 05 SmartVision Controller...
Page 2: ......
