Balluff BAE SA-OH-059-YI-DP02, User Manual

Page: 42 / 62

10 english
5.2 Electrical connection
4-pin (supply) 3-pin (sensor)
Fig. 5-2: Electrical connection for the amplifier (4-pin connection only
on variant -S75G).
Tab. 5-1: Pin Assignment
Factory setting
– Mode: SIO mode
– Operating mode: Standard Power, Standard
Sensor, Standard Speed, Sync Mode Off
– PIN 4/black: PNP switch output
(in IO-Link mode: Push-Pull)
– PIN 2/white: Inactive (PNP)
– Pink on -DP02: Inactive (PNP)
See also document IO-Link-configuration at
www.balluff.com on the product page.
5.3 Shielding and cable routing
The BOH sensor cable is shielded and should not be
extended.
Cable length
For IO-Link operation, the maximum supply cable length is
20 m.
5.1 Installation
For dimensions, see Fig. 4-1 on page 8.
The following mounting types of the sensor amplifiers are
available:
– Simple clamp mounting on DIN rail with dimension of
DIN 35 mm or 15 mm.
– Screw mounting by means of through holes for M3
screws.
– Clamp mounting on DIN rail adapter by means of M3
screws.
Place the device on the DIN rail adapter as shown. Con-
nect the cable according to the connection table.
Fig. 5-1:
Mounting the amplifier
5
Installation and connection
Connection Pin Signal
4-pin
(supply)
-S75G
(plug variant)
1 VDC
L+ (operating
SIO 15…30V,
IO-Link 18…30V)
Max. current consumption:
45mA
2 I/Q
Digital input /
Digital output
3 GND L- (operating voltage- 0V)
4 C/Q
IO-Link communication /
digital output in SIO mode
5-pin
(supply)
-DP02
(cable
variant)
Brown VDC
L+ (operating
SIO 15…30V,
IO-Link 18…30V)
Max. current consumption:
45mA
White I/Q
Digital input /
Digital output
Blue GND L- (operating voltage- 0V)
Black C/Q
IO-Link communication /
digital output in SIO mode
Pink TEACH External teach (input)
3-pin
(sensor)
(all versions)
1 LED+ Transmitter (LED)
3 FT+ Receiver (phototransistor)
4 GND 0V / cable shield
BAE SA-OH-059-YI-----
Photoelectric Sensors