Balluff BAE PD-ML-010-04, Manual

Page: 60 / 76

22 english
7
Specific functions BML SL1 (continued)
7.1.1 BML parameters and functions
The following options are available to change the BML
configuration:
Parameters Options Note
Communication
protocol
BiSS/SSI Sets the type of serial
interface.
Output Not inverted Rising output curve
Inverted Falling output curve
Preset input Disabled To prevent the Preset
input from being
accidentally triggered,
it can be disabled.
Enabled The Preset input is
used to set the
current position value
to a continuous
approx. 10 mm.
Analog filter Disabled Using the analog filter
reduces position
noise. Use of the
analog filter can result
in a lag error.
Low filter
(15 kHz)
High filter
(7.5 kHz)
Signal quality
threshold
Disabled Signal quality
monitoring disabled.
Several
selection
options
(0…100%)
The sensor head
continuously monitors
the signal quality. If
the signal quality
drops below the
threshold value, a
warning is issued
through the digital
interface and the LED
provides a
corresponding
indication.
Tab. 7-1: Parameters BML SL1
The a
naLOg fiLter
and S
ignaL quaLity threShOLD
options are only visible in Enhanced mode (see
chapter 5.3.2 on page 14).
The changes are only applied after the
Write
SySteM COnfiguratiOn
button has been
clicked, and the parameters have been written.
To avoid data loss and malfunctions, do not
remove the sensor head during an update
process.
7.1.2 Write system configuration
DANGER
Uncontrolled system movement
When starting up, if the magnetic encoder system is part
of a closed loop system whose parameters have not yet
been set, the system may perform uncontrolled
movements. This could result in personal injury and
equipment damage.
►
The system must be taken out of operation before
configuration.
►
The sensor head may only be connected to the USB
adapter for configuration.
►
After using the Configuration Tool remove the USB
adapter.
To avoid data loss and malfunctions, do not
remove the sensor head during the write
process.
Clicking on Write
SySteM COnfiguratiOn
sends information
to the sensor head. Transmission takes a certain amount
of time, since all the parameters are sent.
The button Write
SySteM COnfiguratiOnS
is only
active if there are pending changes in
parameters.
7.1.3 Read system configuration
The current sensor head parameters can be read out at
any time using the button reaD S
ySteM
C
OnfiguratiOn
.
When reading out, the parameters shown in the
Configuration Tool are rejected.
This is helpful for example when the parameters
in the Configuration Tool are changed but not
written to the sensor head and you want to
display the original settings currently stored in
the sensor head again.
BAE PD-ML-010-04
Configuration Tool + USB-Adapter