Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Page 3 of 3
FCC INSTRUCTION:
Caution: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Do Not Charge in Rain or Water
Electrical Shock Hazard
Charge in a Dry Indoor Evironment
WARNING
STEP 1: INSTALL CABLE AND CHARGE LAMP
- Connect USB Cable to a computer or any
5V OUTPUT
USB charging unit.
- Insert other end of Cable into DC port on Lamp (A)
- Charge for 5-6 hours (or until fully charged) prior to use.
- Indicator light is RED during CHARGING and GOES OUT when CHARGING IS COMPLETE.
(A)
5v Output
STEP 2: POWERING LAMP
Turn On: Press and hold on/off button for 3 to 5 seconds.
Turn Off: Press and hold on/off button for 3 to 5 seconds.
Adjust Brigtness: Low-Medium-High, quickly press and release.
ON/OFF BUTTON
CHARGING PORT
SOLAR CHARGING: Lamp must be OFF
