Page 4 of 6
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(D)
STEP 2: Orient Stretcher (G) with stepped edge toward front of desk and angled pre-drilled holes
facing up. Gently fit doweled ends into pre-drilled holes in Legs (H). Insert a Screw (D) into each
angled hole and use a Phillips Screwdriver to firmly tighten and secure. NOTE: Be certain Screw pulls
Stretcher tight against side of Leg.
Finally, use Allen Wrench to fully tighten all 10 Allen Bolts previously installed in Step 1.
(G)
(H)
STEP 3: Center Drawer Front may be dropped down to create additional work surface. To release
drawer front, press down on latch lever. Replace by lifting Drawer Front to latch until it clicks and locks.
