ATION
Before Lighting
The gas fire pit should be thoroughly inspected before each
use, and by a qualified service person at least annually.
If relighting a hot gas fire pit, always wait at least 5 minutes.
Lighting instructions
1. Make sure control knob is in the
"OFF" position.
2. Turn propane cylinder gas valve to fully
open position.
3. Press down control knob and turn it
counter clockwise to "IGNITE/LOW"
position, this will light the burner.
4. If the burner is lit, keep pressing down
the control knob for 10 seconds before
releasing it.
5. If the burner is not lit, press down the
control knob and turn clockwise to "OFF"
position, repeat from step 3 after 5 minutes.
6. When burner is lit, turn the control knob to the desired heat output position between
"LOW" and "HIGH".
7. Press down and turn the control knob clockwise to "OFF" position to shut down the appliance.
Turn off cylinder gas valve.
Flame Characteristic
Normally the burner flame is yellow.
If the burner flame is blue and very small, please check the
gas cylinder, as it may be low gas pressure or empty. If there
is enough gas in the cylinder, please contact customer service
to change the burner of the gas fire pit.
If flames lift away from burner or backfire happens,or produce
thick black smoke, the fire pit should be turned off immediately.
The fire pit should not be operated again until the unit is serviced
and/or repaired by a qualified service technician.
WARNING:DO NOT ATTEMPT TO OPERATE THIS HEATER UNTIL YOU HAVE READ
AND UNDERSTAND ALL PRECAUTIONS. FAILURE TO DO SO CAN RESULT IN
PROPERTY DAMAGE,SERIOUS INJURY,OR DEATH.
OPERATION
9
BATTERY COMPARTMENT
IGNITE/LOW
OFF
HIGH
Push to
turn
R
R
