4
METER INTRODUCTION
Operating mode description.
Sleep Mode:
To minimize battery consumption
the meter will revert to sleep mode if left idle
for more than 2 minutes, and will automatically
“power up” when the
reset
button is pressed or
there is flow through the meter.
Operation of Buttons
The control buttons can be used in two ways
1) Press
: Press & release the button.
2) Double
click:
Press & release the button
twice quickly.
Totalizers
There are three totalizers built in to your meter
1) Reset batch total:
To reset batch total
press the
reset
button.
2) Non-reset accumulative total:
This is
located below the batch total and displays
the total volume the meter has dispensed.
3) Reset accumulative total:
Is hidden from
view and is used to track daily, weekly, or
monthly usage.
To View or Reset Total
A)
Double
click the
reset
button (the display
will enter the reset total mode)
B) To reset the resettable total, press and
hold the
reset
button (3 seconds) until the
total zeros.
C) The display will automatically return to
manual mode after 5 seconds.
Changing Units
1) Press and hold the
reset
button for five
seconds. (The units segment starts flash-
ing.)
2)
Press the
reset
button to cycle through the
unit options.
3) Stop at the required setting.
Batch Total
-
Accumulative Total
Liter
Liter
Pint
Gallon
Quart
Gallon
Gallon
Gallon
4) To store the selected units, press and hold
down the Reset button for five seconds
until the batch and accumulative totals
appear. If the reset button is not held down
for 5 seconds, the original settings will be
stored.
Low Battery
The battery segment will flash when the battery
is low and needs replacing.
NOTE:
When the battery segment starts flashing
replace the battery as soon as possible. Use
only Alkaline AA batteries.
Battery Replacement
1) Remove the protective rubber boot.
2) Remove the battery cover screw located
near the inline (forward) outlet port and
remove the battery cover.
3) Replace the two AA Alkaline batteries.
(Check + - are correct)
4) Inspect the battery cover seal for damage
and replace if necessary.
5) Replace battery cover and tighten screw,
while pressing cover in place.
Error Message
If an error is detected in meter operation,
the following error codes will appear on the
display.
Err1 – Sensor error
Err3 – Flow rate too high
Err4 – Calibration error
Err5 – Computer error
To reset the meter after an error message
press
reset
.
