en
8
Rinse aid
As soon as the rinse-aid refill indicator
7
lights up on the control panel,
refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses.
Use only rinse aid for domestic dish-
washers.
Combined detergents with rinse-aid com-
ponent may be used up to a water hard-
ness of 21
_
dH (37
_
fH, 26
_
Clarke,
3,7 mmol/l) only. If the water hardness
is over 21
_
dH, rinse-aid must be used.
Open the dispenser
29
by pressing
and lifting the plate on the cover.
Carefully pour rinse aid up to the max.
mark in the filler opening.
Close cover until it clicks shut.
To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
Setting amount of rinse-aid
The amount of rinse aid dispensed can be
set in 4 stages. Accordingly 0, 1, 2 or 3
displays are lit (see water hardness table).
Factory setting: 2.
Do not change the amount of rinse-aid
unless streaks (select lower setting) or
water stains (select higher setting) are left
on the utensils.
Close the door.
Switch on ON/OFF switch
1
.
Press and hold down the Start button
4
.
Rotate programme selector
3
until the rinse-aid refill indicator
7
flashes.
Release button.
The rinse-aid refill indicator
7
flashes
and the displays
and
are lit
(= Setting 2).
Change the setting as follows:
Rotate programme selector
3
until
the required setting has been selected.
Press Start button
4
.
The rinse-aid refill indicator
7
goes out.
The selected setting is saved.
Switching off rinse-aid refill
indicator
If the rinse-aid refill indicator
7
is
impaired (e.g. when using combined
detergents containing rinse-aid
component), it can be switched off.
Proceed as described under
“Setting amount of rinse aid” and select
setting 0.
The rinse-aid refill indicator
7
is now
switched off.
Summary of Contents for 3VS300BA
Page 1: ...en Instructions for Use Dishwasher...
Page 2: ......
