en
17
Waste water pump
Large food remnants in the rinsing water
not retained by the filters may block the
waste water pump. The rinsing water is
then not pumped out and covers the filter.
In this case:
–
First disconnect the appliance from the
power supply.
–
Remove the filters
1*
.
–
Scoop out water, use a sponge if
required.
–
Loosen screws on the pump cover
(Torx T 20) and pull off.
–
Check inner compartment and remove
any foreign objects.
–
Place pump cover in the original
position, press down and screw tight.
–
Install filters.
The majority of faults which could occur in
daily operation can be rectified by the
user. This ensures that the appliance is
quickly available for use again. The
following overview will help you locating
the causes and gives helpful advise to
eliminate them.
ã=
Warning
If on the digital display
)"
an error code
(
“
:
‹‚
to
“
:
„‹
)
, always disconnect the
appliance from the power supply and then
turn off the tap.
You can rectify certain faults yourself (see
following fault description), for all other
faults please contact customer service and
state the indicated fault
“
:XX.
ã=
Warning
Don’t forget: Repairs may be carried out
by technicians only. If a component has to
be replaced, ensure that only original
spare parts are used. Improper repairs or
use of non-original spare parts may cause
considerable damage and put the user at
considerable risk.
... when the appliance is
switched on
The appliance does not start.
–
The mains fuse has tripped.
–
The appliance plug has not been
inserted.
–
The appliance door has not been shut
properly.
... changing settings
A setting cannot be changed, a
programme starts.
–
Wrong programme button pressed.
Terminate the programme (see chapter
entitled “Terminating the programme
(Reset)”) and start all over again.
–
You did not wait until programme
ended.
Troubleshooting
