8
Installation
– Scope of delivery: dryer, installation and operating instructions
.
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not set up in a room that is susceptible to frost. Freezing water may cause damage.
– If in doubt, have the appliance connected by a specialist.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
Setting up the dryer
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean, level
and firm surface.
– Do not obstruct the air inlet on the front of the
dryer.
– Keep the area around the dryer clean.
– Make the dryer level using the threaded feet
and a spirit level.
– Do not remove the threaded feet under any
circumstances.
Mains connection
see Safety instructions
a
page 13.
– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
– The mains voltage and the voltage shown on the rating plate (
a
page 10
) must be the
same.
– The connected load and necessary fuse protection are specified on the rating plate.
Frost protection
Preparation
1. Empty the condensation container
a
page 4
.
2. Select any programme using the programme selector.
3. Press the
inicio
/pausa
(
start
/pause) button
a
condensed water is pumped into the
container
4. Wait 5 minutes and then empty the condensation container again.
5. Turn the programme selector to
stop
.
Transport
– Prepare the dryer
a
see Frost protection.
– Transport the dryer in a vertical upright position.
– Following transportation, do not use the dryer for two hours.
The dryer contains residual water;
this can flow out if the dryer is tilted.
1.
Take all accessory parts out
of the drum.
The drum must be empty.
Make sure that the air inlet
remains unobstructed
Clean and level
Do not set up the dryer behind a door or sliding
door, as this may obstruct the dryer door or prevent
it from opening. This will prevent a potentially fatal
danger to children from locking themselves in.
2.
Do not operate the dryer if
there is a danger of frost.
9
Care and cleaning
Heat exchanger
The dryer's heat exchanger is cleaned automatically during drying.
Cln
appears in the display
panel. Do not pull out the condensation container during the cleaning process.
Dryer housing, control panel, air intake
Remove detergent residues immediately.
Wipe with a soft, damp cloth.
Filter in the condensation container
The filter is cleaned automatically when the condensation container is emptied.
However, the filter should still be cleaned regularly under running water
a
This prevents
stubborn deposits/dirt from building up.
1.
Pull out the condensation container.
2.
Pull the filter out of its snap-in lock.
3.
Clean the filter under running water or in the dishwasher.
4.
Refit the filter.
5.
Insert the condensation container so that it locks into place.
Only operate the dryer with the filter inserted.
Moisture sensor
The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how
damp the laundry is. A thin layer of limescale may build up on the moisture sensors after
prolonged use.
1.
Open the door.
2.
Clean the moisture sensors using a damp sponge with a rough surface.
Do not use steel wool or abrasive materials.
Appliance must be switched off.
10
Technical data
ʠ
Dimensions (DxWxH)
60 x 60 x 85 cm (height adjustable)
Weight
approximately 51 kg
Max. capacity
7 kg
Condensation container
4.0 l
Connection voltage
220-240 V
Connected load
max. 1000 W
Fuse protection
10 A
Ambient temperature
5 - 35 °C
Product number
Production number
under the door
The rating plate can be found on the back of the dryer.
ʠ
Consumption rates
These are guide values determined under standard
conditions.
Spin speed
in rpm
(residual moisture)
Drying time
in min.**
Energy
consumption
in kWh**
Cottons / Coloureds 7 kg
Cupboard Dry*
1400 (approx. 50 %)
128
1,62
1000 (approx. 60 %)
149
1,90
800 (approx. 70 %)
169
2,19
Iron Dry*
1400 (approx. 50 %)
92
1,13
1000 (approx. 60 %)
113
1,42
800 (approx. 70 %)
133
1,70
Easy-Care 3.5 kg
Cupboard Dry*
800 (approx. 40 %)
54
0,57
600 (approx. 50 %)
68
0,72
*Test programs according to DIN EN 61121
**The values may differ from those given, depending on overvoltage and undervoltage, the
type of fabric, composition of the laundry to be dried, the residual moisture in the fabric and
the size of the load.
ʠ
Drum interior light
(depending on model)
(bulb E14, 25 W)
The drum lights up after the door is opened or closed, and after the programme starts, and
switches off automatically. Changing the bulb
a
page 12
.
Optional accessories
(from after-sales service using order number)
Platform
For easier loading and unloading. The basket contained in the drawer can be used to carry
the laundry.
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. The dryer
must be
fastened to the washing machine using this connection set.
Same as WZ 20310, but with pull-out worktop.
Installation underneath the worktop
Instead of the appliance covering plate, you
must
have a metal cover fitted by a specialist.
WZ
20460
WZ
20310
WZ
20300
WZ
20290
11
Normal noises
During drying, the compressor and the pump generate some noise which is entirely normal.
The compressor in the dryer may occasion-
ally generate a humming noise.
The compressor in the dryer is ventilated
from time to time, which creates a whirring
sound.
The automatic cleaning process causes a
clicking noise.
The process of pumping the condensation
into the condensation container generates
pumping noises.
12
What to do if...
Repairs must only be carried out by the after
ä
sales service or an authorised expert.
Before you contact the after-sales service, please make sure that you are unable to resolve
the problem yourself. You will be charged for advice if a technician is called out, even during
the warranty period. You can find your nearest after-sales service in the enclosed list. When
contacting the after-sales service, please quote the appliance's product number (E-Nr.) and
production number (FD) (
a
on the inside of the door).
ʠ
The
inicio
/pausa
(
start
/
pause) indicator lamp does not
light up.
Mains plug plugged in?
Programme selected?
ʠ
The
s
depósito (Container)
indicator lamp and the
(
start
/pause) button are
flashing.
Empty the condensation container
a
page 4
.
Clean the condensation container filter if necessary
a
page 9
.
Dryer transported?
a
Wait 2 hours and start again.
ʠ
The
r
limp. filtro (Filter)
indicator lamp and
(
start
/
pause) button are flashing.
Rinse the fluff filter under running water
a
page 4
.
ʠ
Cln
appears in the display panel. Not an error. Automatic cleaning of the heat exchanger. Do
not empty the condensation container.
ʠ
Dryer does not start.
inicio
/pausa
(
start
/pause) button selected?
Door closed?
Programme set?
Ambient temperature greater than 5 °C?
ʠ
Water is leaking out.
Make sure the dryer is level.
ʠ
The door opens by itself.
Push the door closed until you hear it click into place.
ʠ
The required degree of dryness
was not achieved or the drying
time was too long.
Rinse the fluff filters under running water
a
page 4.
Empty the condensation container.
Check the water drainage (if applicable).
Ambient temperature greater than 35 °C?
a
Ventilate the
room.
Air inlet may be blocked
a
Keep clear.
Was an unsuitable programme selected?
a
page 7.
Has the dryer been installed with sufficient space on all
sides? Ensure that air can circulate.
Power failure
a
Restart dryer.
Fine layer of limescale on the moisture sensors
a
Clean
the sensors
a
page 6
.
ʠ
Laundry damp.
Select the next drying programme up or use the Timed
programme as a supplement
a
page 7.
Warm laundry feels damper than it really is.
ʠ
The humidity in the room
increases significantly.
Make sure the room is sufficiently ventilated.
Air inlet blocked?
a
Keep clear.
ʠ
Power failure.
Remove laundry from the dryer immediately and spread out.
This allows the heat to dissipate.
ʠ
Other intermittent noises and
vibrations.
Not an error.
Normal noises
a
page 11
.
ʠ
Loud humming noise for several
seconds.
Has the condensation container been properly inserted?
a
Push the condensation container all the way in.
Not an error. Normal noises
a
page 11
.
ʠ
The interior light is not working
(depending on model)
.
Pull out the appliance plug, remove the cover cap in the
interior above the door (use Torx 20 screwdriver) and
replace the bulb
a
page 10
. Close the cover cap. Never
operate the dryer without a cover cap.
ʠ
If you cannot rectify a fault yourself or a repair is necessary:
– Set the programme selector to
stop
.
– Remove the appliance plug from the socket.
– Call the after-sales service
a
after-sales service directory.
13
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
dryer...
– In rooms inside the house.
– To dry fabrics.
The dryer must
NEVER...
– Be used for purposes other than those described above.
– Be modified in terms of its technology or properties.
Hazards
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from pockets,
and lighters in particular
a
Risk of explosion.
– Do not lean or sit on the door
a
Risk of tipping.
Installation
– Secure loose cables
a
Risk of tripping.
– Do not operate a dryer if there is a risk of frost.
Mains
connection
– Connect the dryer to an AC earthed socket according to specifications,
otherwise it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
– Do not use multiple plugs/connectors and/or extension cables.
– Do not touch or hold the appliance plug with wet hands
a
Risk of electric shock.
– Never pull the appliance plug out of the socket by its cable.
– Do not damage the mains lead
a
Risk of electric shock.
Operation
– Only load the drum with laundry.
Check the contents before you switch the dryer on.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
grease or paint (e.g. hair styling products, nail varnish remover, stain remover,
cleaning solvent, etc.)
a
Risk of fire/explosion.
– Dust (e.g. coal dust, flour) poses a danger: Do not use the dryer
a
Risk of explosion
– Do not put laundry containing foamed material/rubber in the dryer
a
elastic
material may be destroyed and the dryer be damaged due to possible
deformation of the foamed material.
– When cleaning the fluff filter, make sure that no foreign material (down or filling
material) gets into the air duct opening. If necessary, clean the drum
beforehand with a vacuum cleaner. If foreign material should still get into the
air duct
a
call the after-sales service
a
Risk of fire/explosion.
– Switch off the dryer once the programme has ended.
– The water from condensation is not drinking water and may be contaminated
with fluff.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Repairs must only be carried out by the after-sales service.
– Do not use the dryer if the mains cable is defective. To avoid danger, only have
the defective mains cable replaced by the after-sales service.
– Always pull the mains plug out of the socket before changing the bulb for the
interior light
a
Risk of electric shock.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Disposal
– Pull out the appliance plug,
then
cut off the mains cable from the appliance.
Dispose of at a municipal waste disposal facility.
– Heat exchangers contain a fluorinated greenhouse gas covered by the Kyoto
protocol (R134a)
a
dispose of in a proper manner. Capacity: 0.22 kg.
– Packaging: Keep all packaging out of reach of babies and children
a
Risk of suffocation.
– All materials are environmentally sound and can be reused. Dispose of in an
environmentally-responsible manner.
Instructions for
installation and use
en
Tumble dryer
Read these instructions before operating the dryer.
Observe the safety instructions on page 13.
