Installing the Tower on the Allegro® 2
Parts List
Description
Part Number
Qty.
Tower frame
617-061
1
Tower receiver brackets (1 pair)
950-171
1
Lower spring mounts (1 pair)
950-170
1
Push-through bar
617-064
1
T-pins
GEN9892 2
SoftTouch Single Loops
101-033
1 pair
Roll Down Bar
701-010
1
Square Bumper
206-002
3
DVD
DVD8377 1
Springs:
Long Yellow Trap Spring
SPR9006
2
Long Purple Trap Spring
SPR9461
2
Short Yellow Trap Spring
SPR9002
2
Short Blue Trap Spring
SPR9004
2
Safety Strap w/ Carabiner
210-023
1
tooLs
Wrench
617-060 1
1. remove head-end of frame
Note
: Two people are recommended for this process.
Lift the head-end (the end
with the risers on it) of the
Reformer and place a sitting
box or some other solid object
underneath the frame rails so
that the head-end is off the
ground. This will support the
rest of the Reformer when the
frame end is removed.
Remove the two nuts at the
head-end of the frame rails
with the included wrench as
shown in Figure A.
Repeat on other side.
Grab a riser and a leg casting
and pull the head-end off
the frame as shown In Figure
B. TIP: Some effort will be
required and rocking the head-
end from side to side may help
to loosen it up.
»
Remove the two black bumpers near the bolt holes on the
end casting and discard. If your reformer does not have them,
proceed to the next step.
2. instaLL tower receivers
Take the Tower receiver brackets (they are attached to the Tower
for shipping purposes) and align them with the bolts at the end
of the frame rails. The bracket will be sandwiched between the
end of the frame rails and the head-end of the frame that was
just removed, as shown in Figure C.
Figure A (shown from underside of
Reformer)
Remove these
two nuts
Figure B
Figure C
Receiver brackets
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | [email protected]
400-229 | 12.10.13
