PARTS LIST
DESCRIPTION
PART NO
QTY
Studio Reformer
Red Springs
SPR9070
3
Blue Spring
SPR7071
1
Green Spring
SPR9293
1
Cotton Loops (pair)
101-005
1
Neoprene Handles (pair)
101-016
1
Ropes (pair)
210-026
1
Carriage Extension Stopper
200-211
1
Sitting Box
721-002
1
Wooden Risers (pair)
950-034
1
Riser Bolts
GEN7314
4
Pully Assembly (pair)
GEN9039
1
Shoulder Rest Kit TwistLock
950-251
1
TwistLock Post
616-400
2
with Classic Footbar
Short Foot Strap
101-011
1
Spring Bar
950-053
1
with Revo Footbar
Revo Foot Strap
210-030
1
with Infinity Footbar
Revo Foot Strap
210-030
1
Complete Infinity footbar with
Trunnions Attached
N/A
1
Footbar Stoppers
REF0702
2
Footbar Stopper Screws
GEN9027
2
Plunger Knob Wrench
ALL0060
1
INSTALL THE CARRIAGE
1. Turn the carriage over and clean both the wheels and the full
length of the rail surfaces inside the frame. Carefully place the
carriage into the frame with the headrest facing away from
the footbar.
ATTACH THE SPRINGS TO THE UNDERSIDE OF
THE CARRIAGE
2. Locate the bracket with
five eye-bolts attached
beneath the carriage. Hook
the springs onto the
eyebolts. The hook should
be facing down.
. The bodies of the springs
should rest on the flat, padded
brace under the carriage (Fig A).
INSTALL THE STANDARD WOODEN RISERS
3. The adjustable riser blocks
come with four screws
and a hex key provided
in a hardware package.
Install the riser blocks to
the outside of the frame
at the head end. The long
slots in the risers go to the
top with the fully rounded
edges facing out as shown
in Figure B. Start threading
both screws by hand in one
riser block before tightening.
. When both screws are
engaged, tighten them with the hex key.
Repeat with the other riser.
ATTACH THE PULLEYS TO THE WOODEN RISERS
4. The hardware package
contains two pulleys with
black knobs. Unscrew the
black knobs and remove.
Take off one of the large
washers from the exposed
bolt on a pulley and install
the bolt through the slot on
a riser.
. Place the washer back onto
the bolt on the backside of
the riser and add the black knob.
. Do this to both risers, making sure the pulleys are facing the
carriage. See Figure C for proper orientation.
. Raise and lower the pulleys by loosening the black knob and
sliding the pulley up or down in the slot, then tighten the black
knob.
ATTACH THE ROPES
5. To attach the ropes,
first engage at least one
carriage spring to the
springbar to hold the
carriage in place. Unroll
and separate the ropes.
6. Clip a cotton loop onto the end of each rope and hang the
loops on the shoulder rests. (Figure D). Thread the other end
of each rope through a pulley and back into the cam cleats on
the carriage to adjust the length. Be sure to go through the
chrome eyestraps on both sides of the cam cleats.
Fig A
Fig B
Fig C
Fig D
2
