background image

INSTALL ADDITIONAL PULLEYS ON RISERS 

1.  Unthread both ropes from the pulleys. Set them aside, you will 

no longer need the ropes or loops.

2.  Slide the existing pulleys to the top of the slot in the riser 

by loosening the black knob and then re-tightening in the 
desired position (Figure H).

3.  Take one of the pulley assemblies and remove the knob and 

one washer from the eyebolt. Insert the eyebolt and pulley 
assembly through the slot in the riser so the pulley faces the 
carriage, and then thread the washer and black knob onto 
the eyebolt from the back of the riser. Before tightening 
completely, slide the pulley assembly to the very bottom of 
the slot, then secure in place.

INSTALL ROPE AND LOOPS

1.  Thread one end of the rope through both pulleys under the 

carriage and pull the ends evenly toward the risers (Figure G). 
 

 
 
 
 
 
 
 
 
 
 
 
 
 

2.  Take one end of the rope and thread up through the lowest 

pulley on the riser. Continue threading the rope up through 
the upper pulley on the riser and pull toward the carriage 
(Figure H). Repeat on the other loose end of the rope.

3.  Using a Soft-Touch connection (Figure I), secure each end of 

the rope to the D-ring on a black Tri-Loop. You are now ready 
to use the Konnector LITE!

IMPORTANT SAFETY NOTE

: Use of the Konnector system in a manner for which it is not intended may result in equipment damage 

and/or injury to the user.  Intense cardio work utilizing jarring movements may overload the system. Balanced Body is not responsible 
for injuries caused by misuse.

Questions? Call Balanced Body Technical Support at 1-800-PILATES (US and Canada) or +1-916-388-2838 (all other countries).

Figure G

Figure H

WARNING: Be sure to tighten the knobs completely 

to prevent them from sliding along the slot when 

under load.

Figure I

3

Reviews: