Installing the Balanced Body
®
Allegro 1A with Riser Konnector
™
The Konnector is compatible with Balanced Body Reformers with
removable shoulder rests ONLY. If you aren’t sure whether this
system will work with your equipment, please contact Balanced
Body at 1-800-PILATES (US and Canada), or +1-916-388-2838
(all other countries).
To view the installation podcast, please visit
www.pilates.com/instructions
TOOLS REQUIRED (NOT INCLUDED):
»
Flathead screw driver
PARTS LIST (INCLUDED):
ITEM
PART NO.
QTY
Konnector Rope
210-073
1
Tri-Loops (Grey)
210-061
2
Tri-Loops (Black) with pulleys
210-060
2
Allegro 1 A Riser Post Assembly
624-007
2
Lower Mount Allegro Assembly
624-006
2
Under Carriage Mount Assembly
624-004
2
Low Support Bracket A1A
624-010
1
Flanged Shoulder Post, Black
624-008
2
Truss Head Screw 1/4-20 x 1-1/4”
GEN9235
2
Flat head cap screw 1/4-20 x 1-3/4”
210-216
4
Button head screw 1/4-20 x 3/4”
GEN7325
2
Plastic Washer A1A Konnector
607-545
2
Washer, Flat, 1/4”
GEN9305
6
1/4-20 Hex Nut
GEN9056
2
5/32” Allen wrench
GEN9282
1
7/16” Wrench
616-113
1
Spacer, Black, 1.5” Diameter**
ALL0516
4
**If your machine has legs disregard these spacers. If you
machine has rubber feet, unscrew each foot. Install the spacer on
top of the threaded rubber foot. Screw the foot/spacer assembly
back on machine so spacer is between the machine and rubber
foot.
WARNING: Using the existing shoulder posts with a Konnector
system can cause the loops to fall off the posts during use
which may cause injury.
REMOVE ROPES, POST AND SHOULDER BRACKETS
1. Remove the ropes from the cam cleats, carriage and pulleys.
They are no longer needed.
2. Remove the detent pin from the shoulder rest bracket.
Remove the shoulder rest bracket from the carriage. Repeat
on the other side.
3. Remove the screw and spacer furthest away from the
shoulder pad on the underside of each bracket. See Figure A.
4. Reusing the same spacer that was on the removed screw,
install spacer onto the truss head screws 1-1/4” long. Using
a flat head screw driver secure the truss head screw to the
bottom of each shoulder rest bracket. From the top side of
each bracket, thread by hand, the flanged shoulder post.
See Figure B.
5. Using the provided 5/32” Allen wrench and 7/16” wrench,
remove the four flat head screws as shown in Figure C. Keep
the nuts, they will be reused.
WARNING: If you are only using some of the loops, the
unused loops MUST be stored on the flanged shoulder
posts.
1
2
3
4
Figure B
Figure A
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | [email protected]
400-450 | 10.29.18
