7
© 2010 Bakker Hydraulic Products B.V.
Nijverheidsweg 6
6662 NG Elst (Gld) The Netherlands
Tel : + 31 481 374757 Fax : + 31 481 375280
Site :
4.6 ELECTRICAL CONNECTION
- Move the switch on the operating panel to the "0" position.
- Mount the junction box with switch supplied next to the crane control panel.
-
Connect the short twin-core cable to the 24 V DC supply on the vehicle.
This supply cable should be protected with an 8 Ampere fuse.
- Fit the long cable with the plug along the boom of the crane.
Make sure that the cable does not snag in any boom position.
- Put the plug into the discharge unit coupling socket.
4.7 CHECK OPERATION
- Check the operation of the attachment with reference to the control overview. Carry
out this check first without a container, then with an empty container.
- The + and
– of the electrical connections may have been inadvertently swapped over.
If this has happened, the movement of the cylinders will not correspond with the
control overview. You should turn the + and the
– around, but before doing so, make
sure the power supply and hydraulics are switched off.
4.8 WORKING WITH THE DISCHARGE UNIT
- Work carefully!
- Connect the attachment and check its operation as described in 4.1 and 4.7.
- Connect the hydraulic hoses in accordance with the colours shown on the
GEJO 18. Red means piston rod is pushed out, blue means piston rod is pushed in.
- Check that everything is in good working condition.
- Attach the attachment to the container.
- Wait until there are no bystanders.
- Slowly manoeuvre the full container above the loading skip on the truck.
- Lower the container until its bottom side is below the level of the top side of the
loading skip.
- Open the container.
- After emptying out the contents, close the container.
- Carefully replace the container.
The path of the crane being swung in or out must be free of obstacles and persons.
