4
© 2010 Bakker Hydraulic Products B.V.
Nijverheidsweg 6
6662 NG Elst (Gld) The Netherlands
Tel : + 31 481 374757 Fax : + 31 481 375280
Site :
E-mail :
2. ASSEMBLING/DISMANTLING :
2.0 THE SUSPENSION PLATE :
Assembly :
Place the suspension plate on the saddle plate. Check that the bolt-holes
in the suspension plate and the saddle plate correspond with each other.
Fit the 4 bolts and nuts) supplied. Tighten everything properly.
After using the product the next time, check the bolts for tightness and
retighten them if necessary.
N.B.:
Always fit the nut on top. Before fitting the suspension plate, determine
first how the hoses will run from your rotator to the cylinder.
2.1 THE ROTATOR :
2.1.1 Assembling the rotator drive shaft :
Place the rotator drive shaft in the suspension plate.
If the outside measurements of the rotator shaft do not correspond with
the inside measurements of the suspension bush, you probably have the
wrong suspension plate for your rotator. If so, contact your supplier.
Rotate your rotator shaft until the hole in the rotator shaft is in front of the
suspension bush hole. After this, mount the suspension pin and the hairpin
spring.
2.1.2 Assembling the rotator with flange fitting :
If you are using a rotator with a flange fitting, the drill-hole pattern in the
saddle plate must correspond with the drill-hole pattern in the rotator.
Now, you just fasten the rotator to the saddle plate with a bolt joint,
according to the instructions of the rotator supplier.
