1. Refer to
and navigate to
page 8: user configuration
.
2. Use the [
] and [
] keys to highlight the
edit passcodes,
security, MB access
, or
set security
option and press
the [
] key (press twice for the set security option) to
confirm your choice.
3. After you have finished configuring these options, press
the [
] key to confirm your selection or press the [
] key
to cancel and return to the previous screen.
IMPORTANT
See the following sections for information in the available
user configuration
options.
3.9.1 The edit passcodes option
This
user
option is available only at the
user-admin
access
level. By means of this option, the
passcodes
for
user-1
to
user-admin
access levels can be modified. In addition, the
user-admin
can also modify the passcode for modbus
access. The
user-1 to user-admin
passcode must be four (4)
characters long, and the
modbus access
passcode must be
from six (6) to nine (9) characters long.
3.9.2 The security timeout option
Use this option to set a timeout period from 1 minute to 60
minutes, after which the meter will switch back to Full-lock
mode if no keypad activity is detected. The programmed
security timeout
period is applicable for
user-1 to user-
admin
access levels.
3.9.3 The modbus access timeout option
Use this option to set a timeout period from 1 minute to
60 minutes for modbus access, after which the meter will
block modbus writes. This programmed modbus access
timeout period is applicable only to
modbus access
.
3.9.4 The set security option
The
user
can set a security level, only if it is below the
current level.
72
Summary of Contents for Panametrics Sentinel LCT8
