Baker Hughes Panametrics PanaFlow Z3, User Manual

Page: 52 / 118

Chapter 3. Programming
40 PanaFlow Z3 User’s Manual
Figure 32: Option I/O Analog Input connections
3.5.5.5 Option IO (Slot2): Calibrating RTD Input
1. Insert RTD sensor and master RTD in temperature bath and turn ON, and set it to desired temperature set point.
2. Use steps as in Section 3.3.2 to navigate to the Input/Output settings page. Refer to Figure 31 above, select
[Option I/O (Slot 2)] and press [ENTER] .
3. Select [AO-AO-AI-R-1000-3W] and press [ENTER] . Then select [RTD Input(S2:4)] and press [ENTER] .
4. Select [RTD Input] and press [ENTER] .
5. Set the number of Calibration points by selecting [No. of RTD Cal points] .
6. Scroll down and select [Calibrate] option.
7. Select [Set point 1] , press [ENTER] and set [Set point 1] to the temperature value selected on the calibrator. Press
[ESCAPE] .
8. Select [Read Value 1] , press [ENTER] , and check the [Read Value 1] reads [Set point 1] value. Once reading is
stabilized on the [Read Value 1] , Press [ENTER] to accept the value or Press [ESCAPE] to cancel the calibration.
9. Repeat steps 7 and 8 for other set points.
10. Once all set points are calibrated, select either [Save] or [Save & Logout] option to save calibration data.
Figure 33: Option I/O RTD Connection