Baker Hughes Panametrics AquaTrans AT600, User Manual

Page: 54 / 174

Chapter 4. Initial setup and programming
44 AquaTrans™ AT600 User’s manual
4.6.2 Programming the digital output menu
Note:
The programming steps for digital output B and digital output C are the same as those for digital output A.
Note:
Digital outputs can be programmed as pulse, frequency or alarm, or they can be turned off.
4.6.2.1 Disable the digital output
To access the digital output menu, on
the initial screen, highlight the lock
symbol and press [√]. The following
screen opens.
Select program and press [√]. The
following screen opens.
Use the [

] or [

] key to select a
specific digit, then use the [

] or [

]
key to change that digit as required.
After all digits are correct, press [√] to
save. Then, press [x] to return to the
previous screen.
In the user preference menu, select
units setting and press the right arrow
key. A screen similar to the following
opens.
Select the desired digital output with
the [

] or [

] arrow keys, and press [√]
to enter the relevant configuration
menu.
To disable digital output B, select off in
the menu and press [√] twice.