Baker Hughes Masoneilan SVIII AP, Installation And Maintenance Manual

Page: 199 / 204

© 2017 Baker Hughes, a GE company, LLC. All rights reserved.
Masoneilan SVI II AP Installation and Maintenance Manual =
|
199
19. Determining an SVI Positioner
Compliance Voltage in a Control System
This discussion explains how to determine compliance voltage for an SVI positioner. It applies to
the SVI II AP, SVI II ESD, SVI II APN and SVi1000.
A definition of compliance voltage is: The voltage that must be available at the control system
output in order to drive the control current through the SVI II AP and all the resistive devices in
series with it.
Measuring the voltage across the SVI II AP terminals doesn't give the true available system
compliance voltage as the positioner self-regulates voltage as current flows through it.
Additionally, it also doesn't confirm what system voltage is available under load conditions.
Therefore, if compliance testing needs to be done, it is best done before installation.
Use a 1K potentiometer as this is the maximum for most analog output cards and as at 20 mA
this equals 20 VDC, which is a sufficient maximum.
Compliance Test Setup
1. Configure a test setup as in Figure 72.
Figure 72 Compliance Voltage Test Setup