Copyright 2013 Baker Hughes Company.
66 | DPI
620G Instruction Manual–English
Chapter
7.
Data Logging
7.1 Set-up
To begin a data logging session, ensure all relevant channels are set to the correct functions,
refer to Section
3. Select Setup to access the Data logging setup menu.
Figure
7
-
2: Data Logging Setup
•
STORAGE AREA
Used to set Internal, SD card or external USB Flash Drive if connected. Only the SD card
can be read when connected to a PC.
•
FILENAME
Enter the required filename (10 characters maximum).
•
TRIGGER
Select one of the following:
a. Key Press (logs one data point each time the button is pressed).
b. Periodic (logs one data point at a set time interval).
•
PERIOD
This option is used to set the time interval for periodic data logging.
To start Data Logging Mode:
1. Select appropriate options and enter filename for Data Log file.
Note:
When entering filename it is first necessary to select destination (INTERNAL, SD
Card or USB FLASH DRIVE)
2. Select the
button.
7.2 Operation
If in periodic mode, to begin data logging tap ‘Start logging’
button.
In Key press mode, log a data point each time by tapping the log button
.
In Data Logging mode, the display data from all active channels is stored at each data point.
To stop data logging at any time, tap the cancel
button.
The data logging indicator flashes on the status bar to indicate whenever a reading is logged.
