Baker Hughes Apollo 3, User Manual

Page: 127 / 277

Copyright 2020 Baker Hughes Company. All rights reserved. Page 127 of 277
• Are you connecting Backspin probes?
– The answer will be no in most applications.
When the wizard is complete, the I/O board analog inputs (Analog Opt 1
– Analog Opt 8) and digital I/O
(EIO Dig Opt 1
– EIO Dig Opt 12) will appear in the Analogs and Digital IO screens. From the Home
Screen select Data -> Analogs or Digital IO
5.2 Setup a Downhole Tool
The Standard template has an Osiris downhole tool pre-configured. To adjust the Osiris Modbus address,
Communication port, or to select a different downhole tool, navigate to Settings -> Menu -> Other Initial
Setup -> Setup DH Tool.
The DH Tool menu is displayed in Figure 98: DH Tool Menu, page 127 .
Figure 98: DH Tool Menu
To change Osiris settings, choose any of the parameters shown in Figure 98: DH Tool Menu, page 127 . To
select a different downhole tool, run the Select Down Hole Tool wizard. This wizard is also used to select
different engineering units for downhole pressure and temperature readings. If you have no downhole tool,
this wizard can be used to remove downhole tool channels and screens.
Information needed by the Select Down Hole Tool wizard:
• Tool to use, current choices include Zenith E, Osiris-Smartguard, GRC Scout 3000, Centinel and No
Downhole Tool.
• Units for pressure channels, current choices include PSI, Bar, kPa, MPa.
• Units for temperature channels, current choices include DegF, DegC.
• Surface Panel or I/O board only (Zenith E only)