Economy Mode:
The Economy mode allows the set point to be reduced by
20
°
F, without actually changing the set temperature. This mode can be
programmed using the Program Key, or it can be overridden by using the
Economy Key. Whenever the Economy Key is used, the Economy programming
is overridden (forced on or off, toggled each time the key is pressed) until
midnight of the current day. At this time, the override is cancelled and standard
operation will begin again. When in Economy Mode, the Economy Icon will
appear in the display window.
FACTORY PRE-SET FILTRATION MODES
Programming Parameters:
Follow these procedures to
set each parameter:
Press and hold the
Program key
for
5-seconds, the program icon will appear. You may
continue to press the
Program key
to access the desired
parameter to be modified. Once you have reached the
parameter to be modified, press the
Enter (Light) key.
Use the Temp. Set keys to adjust the value. If no key has
been pressed for 15-seconds, the programming mode is
exited automatically. During programming, all keys other
than the Program, Enter (Light) and Temp. Set keys will be
ignored.
2
:
Time of Day: (1)
This
is the first parameter and will
automatically appear with the hour flashing. To adjust,
(2)
press the
Enter (Light) key
, use the Temp. Set keys to
adjust the hour from 01: to 12: am or pm.
(3)
Press the
Program
key
then
Enter
(Light) key
to adjust minutes,
use the Temp. Set keys to adjust the minutes from :00 to
:59. Press the
Program key
to confirm the new setting
and wait until controller resets Temperature / Time. Spa
will be programmed.
:
:
2
SPA PROGRAMMING PARAMETERS
1
2
3
00
1
00
1
Baja Spas Self Cleaning Spa Filtration Program has been designed to efficiently circulate 24 hours per day. The circulation
pump system will only turn off when the spa temperature exceeds 4 (four) degrees above the actual temperature set point.
Baja Spas also added other factory filtration modes and conveniences:
Purge Mode:
Everyday at approximately 12:00 Noon, the booster pump will operate for a few minutes to stir up the spa water
through the entire system.
Smart Winter Mode:
In cold climate areas, Baja Spas are equipped with sensors to detect cold climate situations. These
safety sensors will not operate in a power outage. If long outages are expected, it is best to drain and winterize the spa. See
Page 13 for winterizing instructions.
Smart Summer Mode:
In high heat climate areas, Baja Spas circulation filtration system will automatically perform 2 special
filter cycles that run at 10:00AM and 5:00PM respectively for 2 hours each to provide filtration and ozonation.
Economy (EC) - Filtration (FL) Cycles:
DO NOT CHANGE THESE FACTORY PRESET MODES!
Should you accidentally go into the programming mode after setting the clock and the spa topside controller reads F1, 2, 3
(Filtration) or E1,2,3 (Economy)
Do Not Change These Factory Preset Modes.
Simply step away from the spa for 2 minutes and the controls will automatically reset themselves. Changing these modes will
alter the factory preset settings.
10
Summary of Contents for Performance XS
Page 20: ...NOTES SPA SCHEMATIC 19 ...
