24
BREAK-IN
The first month is the most important in the life of your vehicle. Proper operation
during this break-in period will be helpful for assuring maximum life and
performance of your new vehicle. The following guidelines explain proper break-in
procedures.
Maximum Throttle Opening Recommendation
During the first 10 hours of operation, you should always use less than ½ throttle
opening.
Vary the Engine Rotating Speed
Vary the engine rotating speed during the break-in period. This allows the parts to
“load” and then “unload” (allowing the parts to cool). Although it is essential to
place some stress on the engine components during break-in, you must be careful
not to load the engine too much.
Avoid Constant Low Rotating Speed
Operating the engine at constant low rotating speed (light load) can cause parts
to glaze and not seal properly. Allow the engine to accelerate freely without
exceeding the maximum throttle limit.
Allow the Engine Oil to Circulate Before Riding
Allow a few minutes of idling time after warm or cold engine starting. This allows
the lubricating oil to reach all critical engine components.
Observe Your Initial and Most Critical Service
The initial service (break-in maintenance) is the most important service that your
vehicle will receive. Observing a proper break-in operation, will help engine
components seal properly. Maintenance required as part of the initial service
includes proper adjustments, tightening of all bolts & nuts, and replacement of
dirty oil. Timely performance of this service will help you get the best service life
and performance of the engine.
CAUTION
Failure to follow Break-In procedures can significantly shorten the life of your
vehicle.
By not following Break-In procedure, you risk causing excessive wear, and
damaging the engine.
Be careful to correctly follow Break-in Procedure.
