TERMINATION UNIT CONFIGURATION (NTCS02)
INTRODUCTION
A - 2
I-E96-215A
®
Table A-2. Digital Input
Digital Input
Application/Signal Type
Dipshunt Configuration
XU5 - XU7
System Powered E3/E4
Field Powered
1
NOTE: 1. Using the field device to complete the path to ground is commonly referred to as
switching neutral. Using the field device to complete the path to the slave is referred to as
switching hot. If switching hot is the desired method, the field powered dipshunt configu-
ration must be used. If system power is required, it should be wired as a field source. See
Figure
for an example of
switching hot and switching neutral.
Table A-3. Analog Output Type
Analog Input
Application/Signal Type
Dipshunt Configuration
XU9
Both Outputs in Voltage Mode
Output 1 in Voltage Mode, Output
2 in Current Mode
Output 1 in Current Mode, Output
2 in Voltage Mode
Both Outputs in Current Mode (No
Dipshunt Required)
1
2
3
4
5
6
7
8
T00034A
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
T00035A
1
2
3
4
5
6
7
8
