INSTALLATION
SETUP/PHYSICAL INSTALLATION
3 - 2
I-E96-215A
®
SETUP/PHYSICAL INSTALLATION
This section explains the procedures to set switches and jumpers,
and install the QRC. After installing this module, a configuration
must be created to define the functions a QRC will perform.
NOTE: The installation section provides instructions pertaining to the
installation of the QRC only. For complete TU/TM installation, wiring
and cable information, refer to the termination unit/module manual.
Quick Response Controller Installation
The following steps must be performed to install the IMQRC01.
1. Setting the output type and default value for analog output
number 1 (switch S2).
2. Setting the output type and default value for analog output
number 2 (switch S3).
3. Setting the module address, configuration lock status, and
hardware operating mode on switch S4.
4. Setting digital input jumpers J1, J2 and J3 for the type of
digital input.
5. Connecting cables.
6. Installing the module.
shows the location of switch S2, S3 and S4 and edge
connectors.
Figure 3-1. Quick Response Controller
T00030A
P1
P2
P3
STATUS LED
MODULE RESET
SWITCH
S4
S3
S2
1 2 3 4
OPEN
5 6 7 8
OPEN
OPEN
1 2 3 4 5 6
1 2 3 4 5 6
J1
J3
J2
1
2
3
