Bailey Infi 90 IMCPM02, Instructions Manual

Page: 50 / 55

INTRODUCTION
I-E96-221A C - 1
APPENDIX C - NTMP01 TERMINATION UNIT
CONFIGURATION
INTRODUCTION
The IMCPM02 module can use the NTMP01 termination unit
for termination. Figure
C-1 shows the dipshunt configuration
required for connection to a modem. Figure C-2 shows the dip-
shunt configuration required to operate as an EWS port. Fig-
ure
C-3 shows the jumper assignments for handshake signals.
These jumpers are normally installed. Figure C-4 shows the
required jumper settings for J14 through J17. Figure C-5
shows the required jumper setting for J18. Figure C-6 shows
the NTMP01 connector assignments and jumper locations. Fig-
ure
C-7 shows the NTMP01 cable connection.
NOTE: Port 1 is the EWS port. Port 2 is the utility port and is
unavailable.
Figure C-1. NTMP01 Dipshunt Configuration for Modem (DCE)
Connection
Figure C-2. NTMP01 Dipshunt Configuration for EWS (DTE)
Connection
P5-2
P5-3
P5-5
+5 VDC
+5 VDC
RXD
TXD
CTS
RTS
RXD
TXD
CTS
RTS
P5-4
T00052A
1
2
3
4
8
7
6
5
P5-2
P5-3
P5-5
+5 VDC
+5 VDC
RXD
TXD
CTS
RTS
RXD
TXD
CTS
RTS
P5-4
T00053A
1
3
2
4
8
6
7
5