Bailey IMMFP02, Instructions Manual, Page: 55 / 77

INTRODUCTION
I-E96-202B A - 1
APPENDIX A - QUICK REFERENCE MATERIAL
INTRODUCTION
This appendix provides quick reference information to aid in
the hardware configuration of the IMMFP02 Multi-Function
Processor Module. Table
A-1 and A-2 show the settings for
dipswitches SW3 and SW4. Table A-3 shows the jumper set-
tings for jumper J5. Table A-4 is an abbreviated error code list-
ings. Table A-5 shows other LED conditions.
Table A-1. IMMFP02 Dipswitch SW3 Settings
Pole Setting Function
1 0 Normal run.
1 Enable diagnostics using dipswitch UMB1.
2 0 Unused. Do not change setting.
3 0 Controlway (1 Mbaud).
1 Module bus (83.3 kbaud) used.
4 - 8 0 - 31 Controlway or module bus address.
NOTE: 0 = CLOSED or ON, 1 = OPEN or OFF.
Table A-2. IMMFP02 Dipswitch SW4 Settings
Pole Setting Function
1 0 Disable special operations.
1 Enable special operations. Refer to Special Opera-
tions in Section 3 for explanation.
2 0 Disable on-line configuration.
1 Enable on-line configuration.
3 0 Perform NVRAM checksum routine.
1 Inhibit NVRAM checksum routine.
1
4 0 Perform ROM checksum routine.
1 Inhibit ROM checksum routine.
1
5 0 Reserved for future options. Use this setting for nor-
mal operations even though it performs no function
at this time.
1 Reserved for future options. Do not use this setting.
6 0 Normal operation.
1 The compact configuration function.
2
7 0 Normal operation.
1 Initializes NVRAM (erase configuration) memory.
NOTE:This pole must remain CLOSED for normal
operation.