22
22
LUBRICATION AND MAINTENANCE
Daily Maintenance
•
Do a general cleaning by removing dust and metal chips from the machine.
•
Empty dust collection drawer.
•
Inspect and clean filters located on the machine door. Replace as needed. This will vary
based upon amount of use and type of work material.
•
Check and tighten any loose mounting bolts.
•
Inspect the power plug and cord.
•
Keep area around machine clear of debris.
•
Check for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
Note:
When cleaning chips and debris from the machine, use a brush and a shop
vacuum.
DO NOT
blow off the machine with compressed air. The force of the compressed air
may force chips into critical mechanisms or may inflict injury to yourself or others.
Monthly Maintenance
•
Inspect and clean the internal chambers and motor. Accumulated debris on the fan blades
will reduce performance. Dust and debris accumulation on the motor will cause the motor to
overheat and fail.
Note:
The motor, impeller, and chamber cleaning may be altered based upon
actual usage. Whether increasing or decreasing the service frequency, the motor, impeller, and
chamber must be kept clean to provide the best performance and service life.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
Summary of Contents for MDC-1800-1.0
Page 18: ...16 16 Fully assembled...
Page 22: ...20 20 Electrical Diagram...
Page 25: ...23 23 EXPLODED PARTS DIAGRAM...
