Baileigh IP-208, Operator'S Manual

Page: 23 / 44

21
21
ADJUSTING CUTTING HEAD PARALLEL TO TABLE
Cutting Head and Roller Components
1
Infeed Roller
2 Chipbreaker
3 Cutter Head
4 Casting
5 Outfeed Roller
All parallel adjustments have been made to table
before shipment, no further adjustments are
required. The only verification you should make is
to check indirectly the parallel of the cutter head
and table. Proceed with the following:
1. UNPLUG OR DISCONNECT PLANER FROM
POWER SOURCE AND LOCK OUT POWER.
2. Place gauge block between upper head
casting and table, make them contact slightly.
(Fig. 19).
3. Move gauge block to the opposite side,
making them to the same height.
4. Follow the same procedures to check the backside.
Fig. 18
Fig. 19