Baileigh IP-208, Operator'S Manual

Page: 15 / 44

13
13
DUST CHUTE ASSEMBLY
1. Mount the dust chute to the planer hood with
hex head screws & flat washer.
2. Make sure the dust collection system has
sufficient capacity and suction for your planer.
3. Always turn on the dust collection system
before starting the planer. (Fig. 4).
ELECTRICAL
Motor Specifications
Your tool is wired for 220 volt, 60Hz alternating current. Before connecting the tool to the power
source, make sure the machine is cut off from power source.
Connections

A separate electrical circuit should be used for your tools. If an extension cord is used, use
only 3-wire extension cords, which have grounding type plugs and receptacles, which accept
the tool’s plug. Before connecting the motor to the power line, make sure the switch is in the
“OFF” position and be sure that the electric current is of the same characteristics as
indicated on the tool.

All line connections should make good contact. Running on low voltage will damage the
motor.
CAUTION:
HAVE ELECTRICAL UTILITIES CONNECTED TO MACHINE BY
A CERTIFIED ELECTRICIAN!
Check if the available power supply is the same as listed on the machine nameplate.
WARNING:
Make sure the grounding wire (green) is properly connected
to avoid electric shock. DO NOT switch the position of the green grounding wire if
any electrical plug wires are switched during hookup.
Fig. 4