16
16
Footswitch
1. Unstrap and straighten out the footswitch
cable.
2. Grasp the connector end and plug into
the receptacle at the bottom of the
electrical cabinet.
3. Tighten the connector sleeve.
Removing and Installing the Bending Extension Bar
Note:
The bending extension is typically
on the bending leaf. It can be removed to create
shorter reverse bends.
1. Use a marker to mark the top surface of the
extension bar.
2. Remove and retain the mounting bolts (A) and
remove the extension bar and store with the
clamping bars.
3. When installing the extension bar, verify that the
bar and the seat on the bending leaf are clean (B)
and that no metal chips or dirt will prevent the bar
from setting fully into the bending leaf seat.
4. Install the mounting bolts (A) loosely.
5. Verify that the top of the extension bar is flush with
the top surface of the bending leaf and tighten the
mounting bolts keeping the surfaces flush.
figure 5
A
B
Summary of Contents for BB-4816M-V2
Page 12: ...10 10 3 4 1 2...
Page 16: ...14 14 OVERALL DIMENSIONS...
Page 30: ...28 28 PARTS DIAGRAM...
