Baileigh 1006814, Operator'S Manual

Page: 27 / 64

24
24
Homing
IMPORTANT: Don’t Change the home position unless you are sure the position was
lost, damage to the machine and tooling can occur if the home position is set incorrectly.
1. The machine has been homed from the factory and does not need to be re-homed unless
the encoder or drive motor needs servicing. In the Home or “0” position, the flat of the
spindle is parallel to the machine frame. Verify that the spindle is at the home positon using
the manual function before moving to the next step.
a. Measure from each end of
the flat on the spindle to the
edge of the bending frame.
The two dimensions must be
exactly the same in the Home
position. Slow the Motor
Speed to the slowest position
if having difficulties tapping
the foot pedals to get the
exact setting.
2. To set the home position, press the
upper right corner of the screen (Fig
1) to display OEM Screen Fig. 11.
3. Press the Options button (Fig. 11) to
enter the Options screen Fig 12.
4. Press the Set Home button (Fig. 12) to enter the Home screen Fig 13.
5. Once in the Machine Homing screen, follow the directions on the screen to set the home
position.
The Home position is saved even if the power is shut down for a short time such as
overnight. You may lose the home position if power is lost to the machine during a move or if
wiring or electronics are disconnected inside the electrical cabinet.
6. Press the Exit button to keep the existing Home position. Press and hold the save button at
the bottom of the screen to save the new Home position.
A