Baileigh Industrial GS-450, Operator'S Manual

Page: 14 / 42

•
Improper connection of the equipment-grounding conductor can result in risk of electric
shock. The conductor with insulation having an outer surface that is green with or without
yellow stripes is the equipment-grounding conductor. If repair or replacement of the electric
cord or plug is necessary, do not connect the equipment-grounding conductor to a live
terminal.
•
Check with qualified electrician or service personnel if the grounding instructions are not
completely understood, or if in doubt as to whether the machine is properly grounded.
•
Repair or replace damaged or worn cord immediately.
Power cord connection:
1. Turn the main disconnect switch on the control panel to the OFF position.
2. Unwrap the power cord and route the cord away from the machine toward the power supply.
a. Route the power cord so that it will NOT become entangled in the machine in any
way.
b. Route the cord to the power supply in a way that does NOT create a trip hazard.
3. Connect the power cord to the power supply and check that the power cord has not been
damaged during installation.
4. When the machine is clear of any obstruction. The main power switch may be turn ON to test
the operation. Turn the switch OFF when the machine is not in operation.
Check for correct rotation of the motor
1. Close the electrical enclosure door.
2. With power connected and the main disconnect turned ON, the power light ( E ) on the control
panel will be lit.
3. Push the spindle forward start button (F) to start the spindle. The spindle should rotate in a
clockwise direction as looking down on the spindle from and overhead position.
4. If not, disconnect power to the machine, and switch the L1 and L3 wires. DO NOT move the
ground wire.
WARNING:
In all cases, make certain the receptacle in question is
properly grounded. If you are not sure, have a qualified electrician check the
receptacle
.