16
16
ASSEMBLY AND SET UP
Note: A lifting device will be needed, and an assistant is highly recommended.
1. Open the carton and inspect the contents.
2. Lift the base, column, and table assembly out of the
carton and position where the drill is intended to be
placed.
3. Use the mounting holes as a template and mark the
location on the floor for the anchor bolts.
4. Install the anchor bolts (customer supplied) and
secure the base, column, and table assembly to the
floor with the anchor bolts.
5. Using an appropriate lifting devise, carefully lift the
head assembly out of the carton and over the
column.
6. Insert the column into the pocket on the bottom of
the head assembly until the column is fully seated
into the head pocket.
7. Install the slip wedge pin and clamping bolt
assembly into the casting with the taper (A) toward
the column. (Taper shown up for visibility.)
8. Install the treaded wedge pin in from the opposite
side and lightly tighten the clamping bolt.
WARNING:
For your own safety, DO NOT connect the machine to the
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
CAUTION:
Before operating the
drill each day, verify that the head is secured to
the column. Failure to ensure that the head is
secure to the column may allow the head to
twist unexpectedly during operation causing
damage and or injury.
A