Baileigh Industrial DM-10, Operator'S Manual, Page: 21 / 28

19
19
LUBRICATION AND MAINTENANCE
Before Each Use / Daily
•
Check daily for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
•
Ensure area around grinder is clean and well maintained.
•
Side guard must cover the spindle, nut and flange and 75% of the steel brush diameter.
•
Check the work rest gap
– must be no greater than 1/8” (3.1mm) – adjust if necessary.
Note: Replace steel brush if work rest gap cannot be adjusted to less than 1/8
”
(3.1mm).
•
Check steel brush for damaged or flawed
– replace if necessary.
•
Verify the maximum RPM rating of the machine does not exceed the RPM rating on steel
brush.
•
Eye shields must be clean and in position
– replace if cracked or broken.
•
Check work rest gap periodically during use
– adjust as necessary.
•
Tag out machine if a deficiency is found
– do not use the machine until the deficiency has
been corrected.
Weekly
•
On a weekly basis clean the machine and the area around it.
•
Lubricate threaded components and sliding devices.
•
Apply rust inhibitive lubricant to all non-painted surfaces.
Note: Proper maintenance can increase the life expectancy of your machine.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.