Baileigh Industrial BMS-10, Operating Instructions And Parts Manual

Page: 14 / 48

6.0 Setup and assembly
Read and understand the entire
contents of this manual before attempting
assembly or operation. Failure to comply may
cause serious injury.
6.1 Unpacking
Inspect contents for shipping damage or missing parts.
If either is discovered, report it to your distributor.
Do not discard carton or packing material until saw is
assembled and running satisfactorily.
6.2 Shipping contents
1 Miter saw
1 Dust bag
1 Dust port adaptor
1 Hold-down clamp assembly
3 Hex wrenches, 2.5 / 3 / 6 mm
(6 mm wrench is preinstalled in rear handle)
6.3 Tools required for assembly
Hex wrenches – 2.5 mm, 6 mm
(Additional tools may be needed for adjustment
procedures and securing the miter saw to a
workbench.)
6.4 Transporting the saw
Observe the following safety measures to avoid injury
from unexpected saw movement:
•
Disconnect power cord and wrap it around the
storage clips.
•
Bring cutting head to forward position and down,
and lock it in lower position.
•
Lock slide carriage in place.
•
Always use the carrying handles when lifting or
moving to avoid damage to machine.
•
Bend at the knees, not from the back.
6.5 Mounting saw to bench
For stationary use:
Select a location for the saw, such as the top of a
workbench, that provides sufficient room for handling
workpieces. Secure the saw to the bench. Mounting
hardware is not included and must be purchased
separately.
For portable use:
Place saw on a 3/4-in. thick piece of plywood and bolt
the base securely to the plywood using the mounting
holes on base. Mounting hardware is not included and
must be purchased separately.
Use C-clamps to clamp this mounting board to a stable
work surface at the worksite.
6.6 Releasing slide carriage
Loosen slide locking knob (A, Figure 8-1).
When transporting or storing
miter saw, the slide carriage should always be
locked in position.
6.7 Releasing cutting head
When not in use, lock cutting head
in down position. Failure to comply can cause
serious injury or equipment damage.
1. Push down on operating handle.
2. Pull out on head release pin (B, Figure 6-1).
3. Raise cutting head to UP position.
Note:
When not in use, lock cutting head in down
position:
4. Pull out on head release pin (B) and bring cutting
head down.
5. Push in head release pin (B) to lock.
14