Baileigh Industrial B8870, Operator'S Manual

Page: 19 / 32

17
17
MACHINE ADJUSTMENTS
Wheel Replacement
A flat upper and lower wheel are preinstalled on the English wheel. The lower wheel can be
replaced with any of the other lower wheel wheels.
Important : Hold an upper wheel securely when installing or removing it or it may
fall causing injury or damage! Wear steel toe foot-wear to protect your feet.
Upper Wheel Replacement
1. Raise the lower wheel until the top lightly touches the bottom of the upper wheel. This help to
supply some support to the upper wheel.
2. Remove the cotter pin from the inside of the upper wheel axle.
3. Hold the upper wheel firmly to prevent dropping and remove the upper wheel axle.
4. Carefully remove the upper wheel and set it on the upper wheel rack using a bracket
mounting shaft.
5. Place a different upper wheel into the upper wheel bracket.
Note
: Adjust the lower wheel height as needed to allow the upper wheel to fit into
the upper wheel bracket.
6. Align the bracket and wheel bearing holes, insert the axle, and rotate the latch to secure the
wheel.
Lower Wheel Replacement
1. Use a wrench to disengage the quick release cam and lower the lower wheel bracket until it
stops.
2. Remove the lower wheel and replace it with another one.
3. Engage the quick release lever and raise the lower wheel to the operating position.