Copyright 1999-2012, Barcode Automation, inc.
3
INTRODUCTION
This section contains information for proper installation, operation and
maintenance of the Barcode Automation BA-440 DualBeam Barcode
Reader. Each item in this section should be read completely before
proceeding to other sections of this manual. If there are any
questions contact Barcode Automation, inc at 1-800-528-9167 for
assistance.
FCC CLASS A STATEMENT
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with this manual,
may cause interference to radio communications. A class A
computing device, as defined in Part 15, Subpart J of the Federal
Communications Commission rules is designed to provide reasonable
protection against such interference when operated in a commercial
environment. Operation of this equipment in a residence is likely to
cause interference in which case the user, at his own expense, will be
required to take whatever measures necessary to correct the
interference.
CDRH COMPLIANCE STATEMENT
This laser barcode reading system complies with Standard 21CFR,
Subchapter J, for Class II laser products as set forth by the Center for
Devices and Radiological Health. Any alteration or adjustment for
Class II laser products is not authorized, and will void certification of
the system as a Class II laser product. Figure 1 on page 6 shows the
type and location of warning labels affixed to the reader in compliance
of the CDRH standard.
SAFETY PRECAUTIONS
This Barcode Reader incorporates features that provide for maximum
safety. However, it must be recognized that any equipment employing
electrical voltage and emitting direct or scattered radiation may cause
serious damage and/or personal injury if improperly handled. The
following are recommended safeguards that should be observed at all
times.
