12
DISPLAY MANUAL
DP C11.UART
2) Indication information introduction
• Check wheel diameter
Enter into “Information” interface and briefly
press “+” key or “-” key to select “Wheel
Size” and then briefly press “power” key to
check the wheel size.
Briefly press “power” key to exit back to “In-
formation” interface. Press and hold “+” key
and “-” key at the same time to exit back to
main interface or select “BACK”
→
“EXIT” to
exit back main interface.
• Check speed limit
Enter into “Information” interface and briefly
press “+” key or “-” key to select “Speed
Limit” and briefly press “power” key to
check the speed limit. Briefly press “power”
key again to exit back to “Information”
interface. Press and hold “+” key and “-”
key to exit back to main interface or select
“BACK”
→
“EXIT” to exit back main interface.
• Check battery information
Enter into “Information” interface and briefly
press “+” key or “-” key to select “Battery
Info.” And briefly press “power” to confirm
selection. Briefly press “+” key, it display in
turn b01
→
b04
→
b06
→
b07
→
b08
→
b09
→
b10
→
b11
→
b12
→
b13
→
d00
→
d01
→
d02
→
…
→
dn. briefly press “power” to exit back
to “Battery Info.” Press and hold “+” key
and “-” key to exit back main interface or
select“BACK”
→
“EXIT” to exit back to main
interface.
Code
Code definition
unit
b01
Current temperature
℃
b04
Total voltage
mV
b06
Average current
mA
b07
Remaining capacity
mAh
b08
Full charge capacity
mAh
b09
Relative SOC
%
b10
Absolute SOC
%
b11
Cycle
times
b12
Maximum not charg-
ing time
Hour
