BAER
Your Complete Performance Brake Supplier!
Baer Brakes, Inc. 2222 W. Peoria Ave. Phoenix, Arizona 85029
Ph. (602) 233-1411 Fax. (602) 352-8445 Email.
www.baer.com
Page 1 of 8
Installation Instructions
Product: SS4+
11”, Front OE Spindle
Instruction Part Number: 6000475
Vehicle
Revision Date: 13 January 2014
Make:
GM
Model:
Full Size (BelAir, Impala, Biscayne, etc.)
Year(s):
69-70
Notices
– Read and Follow BEFORE ATTEMPTING INSTALLATION
All installations require proper safety procedures and protective eyewear.
All installations assume basic mechanical skill and a factory service manual for the vehicle on
which the installation is to be performed.
All references
to the “left” side of the vehicle correlate to the driver’s side of the vehicle.
Any installation requiring you to remove a wheel or gain access under the vehicle requires use of
jack stands appropriate to the weight of the vehicle. In all cases, jack stands rated for a minimum
of 2-tons is recommended.
A selection of hand tools sufficient to engage in the installation of these products is assumed, and
is the responsibility of the installer to have in his/her possession prior to beginning this
installation. All installations, which require removal of hydraulic hoses and/or bleeding of the
brakes, require appropriate fitting/line wrenches, safety catch can, and protective eyewear. Other
than these items, if unique or special tools are required they will be stated appropriately in the
installation step.
ALWAYS CONFIRM WHEEL FIT PRIOR TO BEGINNING INSTALLATION OF ANY BRAKE
SYSTEM OR “UPSIZED” ROTOR UPGRADE! In addition to checking wheel fitment (available
online at
www.baer.com
), always place the actual corner assembly or a combination of the caliper
assembly onto the rotor, and into the actual wheel. This procedure will reconfirm proper clearance
between the caliper and the wheel before proceeding with the actual installation.
Returns will
not
be accepted for systems that have been partially or completely installed. Use
extreme care when checking wheel fitment to prevent any cosmetic damage.
ATTENTION:
Read this before going any farther! Returns will not be
accepted for ANY installed PART or ASSEMBLY. Use great care to
prevent cosmetic damage when performing wheel fit check. In the event
that a product must be returned, please contact Baer Customer Service
for a RMA Number.
