For more information and latest updates check www.baehrus.com
3
Installation on motorcycle
When developing your baehr communication system product longevity has been a prime concern. Especially
when mounted on the bike you can do a lot to support this even more .
Therefore try to find the most protected and easily accessible spot on the motorcycle when mounting the
controller. (such as under a seat, inside rear valance , or under the side skirts etc.)
The system will give you many years of enjoyment if you do not expose the control unit to excessive heat , do
not mount it directly in the path of spraying water , and keep maximum possible distances from other (
especially magnetic ) loads such as Ignition coils , alternators, ABS control units , thick wiring harnesses etc. .
Lay all cables so that they do not get crushed or bent , compressed or stretched . Also check the turn radius in
the spring as well as suspension travel under load and with body weight on the seat bench.
Route the cables of your baehr communication system and then mount according to their installation
instructions.
Connection to 12V power system power:
The baehr PhoneAdapter is connected in series with
the power supply of your baehr communication
system (please note connection instructions baehr
communication).
To do this, disconnect the power supply of the
communication system on the connector (A).
Now connect the socket of the Phone Adapter power
connector (B1) with the plug of the power connector
(A1) of the communication system.
Connect the other plug of the PhoneAdapter power
connector (B2) to the socket of the power supply (A2)
of the communication system
If you are not sure, ask your baehr dealer!
